C613-50100-01 REV C Command Reference for x930 Series 344
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LOGGING COMMANDS
LOG
BUFFERED (FILTER)
Default By default the buffered log has a filter to select messages whose severity level is
“notices (5)” or higher. This filter may be removed using the no variant of this
command.
Mode Global Configuration
Examples To add a filter to send all messages generated by EPSR that have a severity of
notices or higher to the buffered log, use the following commands:
awplus# configure terminal
awplus(config)# log buffered level notices program epsr
To add a filter to send all messages containing the text “Bridging initialization” to
the buffered log, use the following commands:
awplus# configure terminal
awplus(config)# log buffered msgtext Bridging initialization
To remove a filter that sends all messages generated by EPSR that have a severity
of notices or higher to the buffered log, use the following commands:
awplus# configure terminal
awplus(config)# no log buffered level notices program epsr
To remove a filter that sends all messages containing the text “Bridging
initialization” to the buffered log, use the following commands:
awplus# configure terminal
awplus(config)# no log buffered msgtext Bridging initialization
Related
Commands
clear log buffered
default log buffered
log buffered
log buffered size
log buffered exclude
show log
show log config
To Next Page
Loading...
Need help?
General
