C613-50100-01 REV C Command Reference for x930 Series 417
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
INTERFACE COMMANDS
SHOW
INTERFACE
Figure 11-1: Example output from the show interface command
To display configuration and status information for interface lo, use the
command:
awplus# show interface lo
Figure 11-2: Example output from the show interface lo command
To display configuration and status information for interfaces vlan1 and vlan2,
use the command:
awplus# show interface vlan1,vlan2
awplus#show interface
Interface port1.0.1
Scope: both
Link is UP, administrative state is UP
Thrash-limiting
Status Not Detected, Action link-down, Timeout 60(s)
Hardware is Ethernet, address is 0000.cd24.daeb
index 5001 metric 1 mru 1500
<UP,BROADCAST,RUNNING,MULTICAST>
current duplex full, current speed 1000
configured duplex auto, configured speed auto, configured polarity auto
current ecofriendly lpi
configured ecofriendly lpi
SNMP link-status traps: Sending (Suppressed after 20 traps in 60 sec.)
input packets 2396, bytes 324820, dropped 0, multicast packets 2370
output packets 73235, bytes 406566, multicast packets 7321 broadcast packets 7
Time since last state change: 0 days 16:35:52
...
awplus#show interface lo
Interface lo
Scope: both
Link is UP, administrative state is UP
Hardware is Loopback
index 1 metric 1
<UP,LOOPBACK,RUNNING>
SNMP link-status traps: Disabled
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Time since last state change: 69 days 01:28:47
To Next Page
Loading...
Need help?
General
