Allied Telesis AlliedWare Plus - Page 453

C613-50100-01 REV C Command Reference for x930 Series 453
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
CLEAR
PORT-SECURITY INTRUSION
To clear the history of port-security intrusion list on port1.0.1, use the following
command:
awplus# clear port-security intrusion interface port1.0.1
To see the port-security status on port1.0.1, use the following command:
awplus# show port-security interface port1.0.1
NOTE: Note that the port status is still locked while the history of port violation is
cleared from the database.
To see the intrusion list on port1.0.1, use the following command:
awplus# show port-security intrusion interface port1.0.1
Table 2: Example output from the show port-security intrusion command

awplus#show port-security intrusion interface port1.0.1
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.1 - 1 intrusion(s) detected
801f.0200.19da
Table 3: Example output from the show port-security interface command

awplus#show port-security interface port1.0.1
Port Security configuration
------------------------------------------------------------
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Lock Status : LOCKED
Security Violation Count : 0
Last Violation Source Address : None
Table 4: Example output from the show port-security intrusion command

awplus#show port-security intrusion interface port1.0.1
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.1 - no intrusions detected