C613-50100-01 REV C Command Reference for x930 Series 531
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
MODE PRIVATE-VLAN TRUNK PROMISCUOUS
Examples To create the isolated VLANs 2, 3 and 4 and then enable port1.0.2 in trunk
mode as a promiscuous port for these VLANs with the group ID of 3, use the
following commands:
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 2-4
awplus(config-vlan)# private-vlan 2 isolated
awplus(config-vlan)# private-vlan 3 isolated
awplus(config-vlan)# private-vlan 4 isolated
awplus(config-vlan)# exit
awplus(config)# interface port1.0.2
awplus(config-if)# switchport mode trunk
awplus(config-if)# switchport trunk allowed vlan add 2-4
awplus(config-if)# switchport mode private-vlan trunk
promiscuous group 3
To remove port1.0.2 in trunk mode as a promiscuous port for a private VLAN, use
the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no switchport mode private-vlan trunk
promiscuous
Note that you must remove the secondary port or ports enabled as trunk ports that
are associated with the promiscuous port before removing the promiscuous port.
Related
Commands
switchport mode private-vlan trunk secondary
switchport mode trunk
switchport trunk allowed vlan
switchport trunk native vlan
show vlan private-vlan
To Next Page
Loading...
Need help?
General
