C613-50100-01 REV C Command Reference for x930 Series 538
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
TRUNK ALLOWED VLAN
NOTE: Only use the add or the remove parameters with this command if a list of
VLANs are configured on a port. Only use the except parameter to remove VLANs after
either the except or the all parameters have first been used to add a list of VLANs to a
port.
To remove a VLAN, where the configuration for port1.0.6 shows the below
output:
Remove VLAN 3 by re-entering the except parameter with the list of VLANs to
remove, instead of using the remove parameter, as shown in the command
example below:
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# switchport trunk allowed vlan except 3,4
Then the configuration is changed after entering the above commands to remove
VLAN 3:
To add a VLAN, where the configuration for port1.0.6 shows the below output:
awplus#show running-config
!
interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 4
awplus#show running-config
!
interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 3-4
awplus#show running-config
!
interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 3-5
To Next Page
Loading...
