C613-50100-01 REV C Command Reference for x930 Series 638
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LINK AGGREGATION COMMANDS
CHANNEL
-GROUP
Examples To add device port1.0.6 to a newly created LACP channel group 2 use the
commands below:
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# channel-group 2 mode active
To remove device port1.0.6 from any created LACP channel groups use the
command below:
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no channel-group
To reference channel group 2 as an interface, use the following commands:
awplus# configure terminal
awplus(config)# interface po2
awplus(config-if)#
Related
Commands
show etherchannel
show etherchannel detail
show etherchannel summary
show port etherchannel
To Next Page
Loading...
