C613-50100-01 REV C Command Reference for x930 Series 670
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE MAX
See the LLDP Feature Overview and Configuration Guide for information about
power monitoring at the PD.
Note the difference in power supplied from the PSE to the power available at the
PD due to line loss.
See the PoE Feature Overview and Configuration Guide for further information
about the difference between the power supplied from the PSE and the power
available at the PD.
Examples To set the maximum power supplied to ports in the range port1.0.1 to port1.0.4 to
6450mW per port, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2-port1.0.4
awplus(config-if)# power-inline max 6450
To clear the user-configured maximum power supplied to port1.0.1, and revert to
using the default maximum power, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no power-inline max
Related
Commands
show power-inline interface
show running-config power-inline
To Next Page
Loading...
Need help?
General
