Allied Telesis AlliedWare Plus - Page 878

C613-50100-01 REV C Command Reference for x930 Series 878
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
IP
RIP AUTHENTICATION KEY-CHAIN
5) Specify the mode of authentication for the given interface (text or MD5),
using the following command:
awplus(config-if)# ip rip authentication mode {md5|text}
Example In the following example of a configuration for multiple keys authentication, a
password “toyota” is set for key 1 in key chain “cars”. Authentication is enabled on
vlan2 and the authentication mode is set to MD5:
awplus# configure terminal
awplus(config)# key chain cars
awplus(config-keychain)# key 1
awplus(config-keychain-key)# key-string toyota
awplus(config-keychain-key)# accept-lifetime 10:00:00 Oct 08
2016 duration 43200
awplus(config-keychain-key)# send-lifetime 10:00:00 Oct 08 2016
duration 43200
awplus(config-keychain-key)# exit
awplus(config-keychain)# exit
awplus(config)# interface vlan2
awplus(config-if)# ip rip authentication key-chain cars
awplus(config-if)# ip rip authentication mode md5
Example In the following example, the VLAN interface vlan23 is configured to use key-chain
authentication with the keychain “mykey”. See the key command for a description
of how a key chain is created.
awplus# configure terminal
awplus(config)# interface vlan23
awplus(config-if)# ip rip authentication key-chain mykey
Related
Commands
accept-lifetime
send-lifetime
ip rip authentication mode
ip rip authentication string
key
key chain