EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #880 background imageLoading...
Page #880 background image
C613-50100-01 REV C Command Reference for x930 Series 880
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
IP
RIP AUTHENTICATION MODE
Usage: multiple
key
For multiple keys authentication, use the following steps to configure a route to
enable RIPv2 authentication using multiple keys at different times:
1) Define a key chain with a key chain name, using the following commands:
awplus# configure terminal
awplus(config)# key chain <key-chain-name>
2) Define a key on this key chain using the following command:
awplus(config-keychain)# key <keyid>
3) Define the password used by the key, using the following command:
awplus(config-keychain-key)# key-string <key-password>
4) Enable authentication on the desired interface and specify the key chain to
be used, using the following commands:
awplus(config-if)# ip rip authentication key-chain
<key-chain-name>
5) Specify the mode of authentication for the given interface (text or MD5),
using the following commands:
awplus(config-if)# ip rip authentication mode {md5|text}
Example 1 In the following example of a configuration for multiple keys authentication, a
password of “toyota” is set for key 1 in key chain “cars”. Authentication is enabled
on vlan2 and the authentication mode is set to MD5:
awplus# configure terminal
awplus(config)# key chain cars
awplus(config-keychain)# key 1
awplus(config-keychain-key)# key-string toyota
awplus(config-keychain-key)# accept-lifetime 10:00:00 Oct 08
2016 duration 43200
awplus(config-keychain-key)# send-lifetime 10:00:00 Oct 08 2016
duration 43200
awplus(config-keychain-key)# exit
awplus(config-keychain)# exit
awplus(config)# interface vlan2
awplus(config-if)# ip rip authentication key-chain cars
awplus(config-if)# ip rip authentication mode md5
Example 2 The following example shows MD5 authentication configured on VLAN interface
vlan2, ensuring authentication of RIP packets received on this interface.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip rip authentication mode md5

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals