C613-50100-01 REV C Command Reference for x930 Series 963
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
AUTO
-COST REFERENCE BANDWIDTH
Calculation result = 0.1
Result after rounding up to the nearest integer = 1 (Interface cost is 1)
The auto-cost reference bandwidth value should be consistent across all OSPF
routers in the OSPF process.
Note that using the ip ospf cost command on a layer 3 interface will override the
cost calculated by the reference bandwidth command.
Mode Router Configuration
Example
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# auto-cost reference-bandwidth 1000
Related
Commands
ip ospf cost
To Next Page
Loading...
