Cisco Catalyst 2960 Series

Example: Configuring a Host Statically to Join a Group 162
Example: Enabling IGMP Immediate Leave 162
Example: Setting the IGMP Snooping Querier Source Address 162
Example: Setting the IGMP Snooping Querier Maximum Response Time 162
Example: Setting the IGMP Snooping Querier Timeout 163
Example: Setting the IGMP Snooping Querier Feature 163
Example: Configuring IGMP Profiles 163
Example: Applying IGMP Profile 163
Example: Setting the Maximum Number of IGMP Groups 163
Example: Configuring MVR Global Parameters 164
Example: Configuring MVR Interfaces 164
Additional References 164
Feature History and Information for IGMP Snooping 165
PART III IPv6 167
CHAPTER 12 Configuring MLD Snooping 169
Finding Feature Information 169
Information About Configuring IPv6 MLD Snooping 169
Understanding MLD Snooping 170
MLD Messages 170
MLD Queries 171
Multicast Client Aging Robustness 171
Multicast Router Discovery 171
MLD Reports 172
MLD Done Messages and Immediate-Leave 172
Topology Change Notification Processing 172
MLD Snooping in Switch Stacks 173
How to Configure IPv6 MLD Snooping 173
Default MLD Snooping Configuration 173
MLD Snooping Configuration Guidelines 174
Enabling or Disabling MLD Snooping on the Switch (CLI) 174
Enabling or Disabling MLD Snooping on a VLAN (CLI) 175
Configuring a Static Multicast Group (CLI) 176
Configuring a Multicast Router Port (CLI) 177
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
x
Contents