Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Specify the port-channel interface name assigned when
the EtherChannel was created. Enters the interface range
configuration mode.
interface range Interface_name
Example:
Switch(config)# interface Po11
Step 2
Enter the do show interfaces summary command
for quick reference to interface names and types.
Tip
Attaches the IPv6 Snooping policy to the interface or the
specified VLANs on that interface. The default policy is
attached if the attach-policy option is not used.
ipv6 snooping [attach-policy policy_name [ vlan {vlan_ids |
add vlan_ids | except vlan_ids | none | remove vlan_ids | all}
] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none |
remove vlan_ids | all} ]
Step 3
Example:
Switch(config-if-range)# ipv6 snooping attach-policy
example_policy
or
Switch(config-if-range)# ipv6 snooping attach-policy
example_policy vlan 222,223,224
or
Switch(config-if-range)#ipv6 snooping vlan 222,
223,224
Confirms that the policy is attached to the specified
interface without exiting the configuration mode.
do show running-config interfaceportchannel_interface_name
Example:
Switch#(config-if-range)# do show running-config
int po11
Step 4
Related Topics
Information about First Hop Security in IPv6, on page 678
Information about First Hop Security in IPv6, on page 678
How to Configure the IPv6 Binding Table Content
Beginning in privileged EXEC mode, follow these steps to configure IPv6 Binding Table Content :
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
685
How to Configure the IPv6 Binding Table Content

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000