Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
(Optional) Specifies the LLDP TLVs to send or receive.lldp tlv-select
Example:
Switch(config)# tlv-select
Step 6
Specifies the interface on which you are enabling LLDP, and
enter interface configuration mode.
interface interface-id
Example:
Switch (config)# interface
Step 7
gigabitethernet2/0/1
(Optional) Specifies the LLDP-MED TLVs to send or receive.lldp med-tlv-select
Example:
Switch (config-if)# lldp
Step 8
med-tlv-select inventory management
Returns to privileged EXEC mode.end
Example:
Switch (config-if)# end
Step 9
Verifies the configuration.show lldp
Example:
Switch# show lldp
Step 10
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 11
Configuring LLDP-MED TLVs
By default, the switch only sends LLDP packets until it receives LLDP-MED packets from the end device.
It then sends LLDP packets with MED TLVs, as well. When the LLDP-MED entry has been aged out, it again
only sends LLDP packets.
By using the lldp interface configuration command, you can configure the interface not to send the TLVs
listed in the following table.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
65
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000