Cisco Catalyst 2960 Series

PurposeCommand or Action
or
Switch(config)# service timestamps log datetime
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
Enabling and Disabling Sequence Numbers in Log Messages
If there is more than one log message with the same time stamp, you can display messages with sequence
numbers to view these messages. By default, sequence numbers in log messages are not displayed.
This task is optional.
SUMMARY STEPS
1.
configure terminal
2.
service sequence-numbers
3.
end
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enables sequence numbers.service sequence-numbers
Example:
Switch(config)# service sequence-numbers
Step 2
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1605
How to Configure System Message Logs