Cisco Catalyst 2960 Series User Manual

Table 70: Default CoS-to-DSCP Map
DSCP ValueCoS Value
00
81
162
243
324
405
486
567
Related Topics
Default Mapping Table Configuration, on page 568
Configuring the CoS-to-DSCP Map, on page 604
Configuring the Policed-DSCP Map, on page 607
Default IP-Precedence-to-DSCP Map
You use the IP-precedence-to-DSCP map to map IP precedence values in incoming packets to a DSCP value
that QoS uses internally to represent the priority of the traffic. The following table shows the default
IP-precedence-to-DSCP map. If these values are not appropriate for your network, you need to modify them.
Table 71: Default IP-Precedence-to-DSCP Map
DSCP ValueIP Precedence Value
00
81
162
243
324
405
486
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
569
Information About QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000