Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Authenticates the CA by getting the public key of the CA. Use the
same name used in Step 5.
crypto ca authentication name
Example:
Switch(config)# crypto ca authentication
Step 11
your_trustpoint
Obtains the certificate from the specified CA trustpoint. This
command requests a signed certificate for each RSA key pair.
crypto ca enroll name
Example:
Switch(config)# crypto ca enroll
your_trustpoint
Step 12
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 13
Monitoring Secure HTTP Server and Client Status
To monitor the SSL secure server and client status, use the privileged EXEC commands in the following table.
Table 111: Commands for Displaying the SSL Secure Server and Client Status
PurposeCommand
Shows the HTTP secure client configuration.show ip http client secure status
Shows the HTTP secure server configuration.show ip http server secure status
Shows the generated self-signed certificate for secure
HTTP connections.
show running-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1137
Monitoring Secure HTTP Server and Client Status

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000