Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
•
zone—Enters the name of the time zone to be displayed when
standard time is in effect. The default is UTC.
•
hours-offset—Enters the hours offset from UTC.
•
(Optional) minutes-offset—Enters the minutes offset from
UTC. This available where the local time zone is a percentage
of an hour different from UTC.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 5
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 6
startup-config
Configuring Summer Time (Daylight Saving Time)
To configure summer time (daylight saving time) in areas where it starts and ends on a particular day of the
week each year, perform this task:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
clock summer-time zone date date month year hh:mm date month year hh:mm [offset]]
4.
clock summer-time zone recurring [week day month hh:mm week day month hh:mm [offset]]
5.
end
6.
show running-config
7.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1533
How to Administer the Switch

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000