Cisco Catalyst 2960 Series User Manual

Table 48: ifIndex Values
ifIndex RangeInterface Type
1–4999
SVI
5
5001–5048
EtherChannel
5078–5142
Tunnel
10000–14500
Physical (such as Gigabit Ethernet or SFP
6
-module interfaces) based on type and
port numbers
14501Null
24567+Loopback and Tunnel
5
SVI = switch virtual interface
6
SFP = small form-factor pluggable
Default SNMP Configuration
Default SettingFeature
Disabled
7
.SNMP agent
None configured.SNMP trap receiver
None enabled except the trap for TCP connections (tty).SNMP traps
If no version keyword is present, the default is Version 1.SNMP version
If no keyword is entered, the default is the noauth (noAuthNoPriv) security
level.
SNMPv3 authentication
If no type is specified, all notifications are sent.SNMP notification type
7
This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration commands.
SNMP Configuration Guidelines
If the switch starts and the switch startup configuration has at least one snmp-server global configuration
command, the SNMP agent is enabled.
An SNMP group is a table that maps SNMP users to SNMP views. An SNMP user is a member of an SNMP
group. An SNMP host is the recipient of an SNMP trap operation. An SNMP engine ID is a name for the local
or remote SNMP engine.
When configuring SNMP, follow these guidelines:
•
When configuring an SNMP group, do not specify a notify view. The snmp-server host global
configuration command auto-generates a notify view for the user and then adds it to the group associated
with that user. Modifying the group's notify view affects all users associated with that group.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
451
Information About SNMP

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000