You can remotely monitor system messages by viewing the logs on a syslog server or by accessing the switch
through Telnet, through the console port, or through the Ethernet management port. In a switch stack, all stack
member consoles provide the same console output.
The syslog format is compatible with 4.3 BSD UNIX.Note
System Log Message Format
System log messages can contain up to 80 characters and a percent sign (%), which follows the optional
sequence number or time-stamp information, if configured. Depending on the switch, messages appear in one
of these formats:
•
seq no:timestamp: %facility-severity-MNEMONIC:description (hostname-n)
•
seq no:timestamp: %facility-severity-MNEMONIC:description
The part of the message preceding the percent sign depends on the setting of these global configuration
commands:
•
service sequence-numbers
•
service timestamps log datetime
•
service timestamps log datetime [localtime] [msec] [show-timezone]
•
service timestamps log uptime
Table 146: System Log Message Elements
DescriptionElement
Stamps log messages with a sequence number only
if the service sequence-numbers global configuration
command is configured.
seq no:
Date and time of the message or event. This
information appears only if the service timestamps
log [datetime | log] global configuration command
is configured.
timestamp formats:
mm/dd h h:mm:ss
or
hh:mm:ss (short uptime)
or
d h (long uptime)
The facility to which the message refers (for example,
SNMP, SYS, and so forth).
facility
Single-digit code from 0 to 7 that is the severity of
the message.
severity
Text string that uniquely describes the message.
MNEMONIC
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1598
Information About Configuring System Message Logs
To Next Page
Loading...
Need help?
General
