•
A protected port does not forward any traffic (unicast, multicast, or broadcast) to any other port that is
also a protected port. Data traffic cannot be forwarded between protected ports at Layer 2; only control
traffic, such as PIM packets, is forwarded because these packets are processed by the CPU and forwarded
in software. All data traffic passing between protected ports must be forwarded through a Layer 3 device.
•
Forwarding behavior between a protected port and a nonprotected port proceeds as usual.
Because a switch stack represents a single logical switch, Layer 2 traffic is not forwarded between any protected
ports in the switch stack, whether they are on the same or different switches in the stack.
Default Protected Port Configuration
The default is to have no protected ports defined.
Protected Ports Guidelines
You can configure protected ports on a physical interface (for example, Gigabit Ethernet port 1) or an
EtherChannel group (for example, port-channel 5). When you enable protected ports for a port channel, it is
enabled for all ports in the port-channel group.
How to Configure Protected Ports
Configuring a Protected Port
Before You Begin
Protected ports are not pre-defined. This is the task to configure one.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
switchport protected
5.
end
6.
show interfaces interface-id switchport
7.
show running-config
8.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1501
How to Configure Port Security
To Next Page
Loading...
Need help?
General
