PurposeCommand or Action
Example:
Switch# show power inline police
Switch# show errdisable recovery
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 9
Monitoring Power Status
Table 11: Show Commands for Power Status
PurposeCommand
(Optional) Displays the status of the internal power
supplies for each switch in the stack or for the
specified switch.
The range is 1 to , depending on the switch member
numbers in the stack. These keywords are available
only on stacking-capable switches.
show env power switch [switch-number]
Displays PoE status for a switch or switch stack, for
an interface, or for a specific switch in the stack.
show power inline [interface-id | module
switch-number]
Displays the power policing data.show power inline police
Configuration Examples for Configuring PoE
Budgeting Power: Example
When you enter one of the following commands,
•
[no] power inline consumption default wattage global configuration command
•
[no] power inline consumption wattage
interface configuration command
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
100
Monitoring Power Status
To Next Page
Loading...
