Cisco Catalyst 2960 Series User Manual

Table 114: Commands for Displaying Access Lists and Access Groups
PurposeCommand
Displays the contents of one or all current IP and MAC address
access lists or a specific access list (numbered or named).
show access-lists [number | name]
Displays the contents of all current IP access lists or a specific
IP access list (numbered or named).
show ip access-lists [number | name]
Displays detailed configuration and status of an interface. If IP
is enabled on the interface and ACLs have been applied by using
the ip access-group interface configuration command, the access
groups are included in the display.
show ip interface interface-id
Displays the contents of the configuration file for the switch or
the specified interface, including all configured MAC and IP
access lists and which access groups are applied to an interface.
show running-config [interface
interface-id]
Displays MAC access lists applied to all Layer 2 interfaces or
the specified
Layer 2 interface.
show mac access-group [interface
interface-id]
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1205
Monitoring IPv4 ACLs

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000