Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Example:
Switch(config-if)# ipv6 address
2001:0DB8:c18:1::/64 eui 64
Switch(config-if)# ipv6 address
2001:0DB8:c18:1::/64
Switch(config-if)# ipv6 address
2001:0DB8:c18:1:: link-local
Switch(config-if)# ipv6 enable
configured when IPv6 is enabled on the interface. This
command enables IPv6 processing on the interface.
•
Automatically configures an IPv6 link-local address on
the interface, and enables the interface for IPv6
processing. The link-local address can only be used to
communicate with nodes on the same link.
Returns to global configuration mode.exit
Example:
Switch(config-if)# exit
Step 8
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 9
Verifies your entries.
show ipv6 interface interface-id
Example:
Switch# show ipv6 interface gigabitethernet
Step 10
1/0/1
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 11
Configuring IPv6 ICMP Rate Limiting (CLI)
ICMP rate limiting is enabled by default with a default interval between error messages of 100 milliseconds
and a bucket size (maximum number of tokens to be stored in a bucket) of 10.
Beginning in privileged EXEC mode, follow these steps to change the ICMP rate-limiting parameters:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
192
Information About Configuring IPv6 Host Functions

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000