Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
For type, enter the model number of a supported switch that is
listed in the command-line help strings.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 5
Removing Provisioned Switch Information
Before you begin, you must remove the provisioned switch from the stack. This optional task is available
only from the active switchstack master.
SUMMARY STEPS
1.
configure terminal
2.
no switch stack-member-number provision
3.
end
4.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Removes the provisioning information for the
specified member.
no switch stack-member-number provision
Example:
Switch(config)# no switch 3 provision
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
740
How to Configure a Switch Stack

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000