SUMMARY STEPS
1.
enable
2.
configure terminal
3.
cns template connect name
4.
cli config-text
5.
Repeat Steps 3 to 4 to configure another CNS connect template.
6.
exit
7.
cns connect name [retries number] [retry-interval seconds] [sleep seconds] [timeout seconds]
8.
discover {controller controller-type | dlci [subinterface subinterface-number] | interface [interface-type]
| line line-type}
9.
template name [... name]
10.
Repeat Steps 8 to 9 to specify more interface parameters and CNS connect templates in the CNS connect
profile.
11.
exit
12.
hostname name
13.
ip route network-number
14.
cns id interface num {dns-reverse | ipaddress | mac-address} [event] [image]
15.
cns id {hardware-serial | hostname | string string | udi} [event] [image]
16.
cns config initial {hostname | ip-address} [port-number] [event] [no-persist] [page page] [source
ip-address] [syntax-check]
17.
end
18.
show running-config
19.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
419
How to Configure the Configuration Engine
To Next Page
Loading...
