Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enables the interface to send LLDP packets.lldp transmit
Example:
Switch(config-if)# lldp transmit
Step 5
Enables the interface to receive LLDP packets.lldp receive
Example:
Switch(config-if)# lldp receive
Step 6
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 7
Verifies the configuration.show lldp
Example:
Switch# show lldp
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 9
Configuring LLDP Characteristics
You can configure the frequency of LLDP updates, the amount of time to hold the information before discarding
it, and the initialization delay time. You can also select the LLDP and LLDP-MED TLVs to send and receive.
Steps 2 through 5 are optional and can be performed in any order.Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
63
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000