Cisco Catalyst 2960 Series User Manual

Example: Setting the IGMP Snooping Querier Timeout
This example shows how to set the IGMP snooping querier timeout to 60 seconds:
Switch# configure terminal
Switch(config)# ip igmp snooping querier timeout expiry 60
Switch(config)# end
Related Topics
Configuring the IGMP Snooping Querier , on page 142
IGMP Snooping, on page 118
Example: Setting the IGMP Snooping Querier Feature
This example shows how to set the IGMP snooping querier feature to Version 2:
Switch# configure terminal
Switch(config)# no ip igmp snooping querier version 2
Switch(config)# end
Related Topics
Configuring the IGMP Snooping Querier , on page 142
IGMP Snooping, on page 118
Example: Configuring IGMP Profiles
This example shows how to create IGMP profile 4 allowing access to the single IP multicast address and how
to verify the configuration. If the action was to deny (the default), it would not appear in the show ip igmp
profile output display.
Switch(config)# ip igmp profile 4
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 229.9.9.0
Switch(config-igmp-profile)# end
Switch# show ip igmp profile 4
IGMP Profile 4
permit
range 229.9.9.0 229.9.9.0
Example: Applying IGMP Profile
This example shows how to apply IGMP profile 4 to a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp filter 4
Switch(config-if)# end
Example: Setting the Maximum Number of IGMP Groups
This example shows how to limit to 25 the number of IGMP groups that a port can join:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp max-groups 25
Switch(config-if)# end
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
163
Configuration Examples for IGMP Snooping and MVR

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000