Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 7
Related Topics
IGMP Filtering and Throttling, on page 126
Restrictions for IGMP Snooping, on page 116
Setting the Maximum Number of IGMP Groups
Follow these steps to set the maximum number of IGMP groups that a Layer 2 interface can join:
Before You Begin
This restriction can be applied to Layer 2 ports only; you cannot set a maximum number of IGMP groups on
routed ports or SVIs. You also can use this command on a logical EtherChannel interface but cannot use it
on ports that belong to an EtherChannel port group.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
ip igmp max-groups number
5.
end
6.
show running-config interface interface-id
7.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
155
How to Configure IGMP Snooping and MVR

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000