Event_reqinfo For EEM_EVENT_NEIGHBOR_DISCOVERY
"event_id %u event_type %u event_type_string {%s} event_pub_sec %u event_pub_msec %u
event_severity %u nd_notification {%s}"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
An ASCII string that represents the name of the event
for this event type.
event_type_string
The time, in seconds and milliseconds, at which the
event was published to the EEM.
event_pub_sec event_pub_msec
The severity of the event.event_severity
Common Event_Reqinfo
The type of notification--cdp-add, cdp-update,
cdp-delete, lldp-add, lldp-update, lldp-delete, link,
line.
nd_notification
The current interface link status, up or down.nd_intf_linkstatus
The current interface line status, down, goingdown,
init, testing, up, reset, admindown, deleted.
nd_intf_linestatus
The local interface name for the event.nd_local_intf_name
The short name of the local interface for the event.nd_short_local_intf_name
The port id as identified by either the cdp or lldp
protocol. This is not set for link or line protocol
events.
nd_port_id
CDP-specific Event_reqinfo
Identifies which protocol triggered the event, for CDP
it will always be set to cdp.
nd_protocol
Identifies which type of protocol event triggered the
event, add, update or delete.
nd_proto_notif
If set to 1, the event was triggered because the cache
entry is new, otherwise it will be set to 0.
nd_proto_new_entry
The name of the cdp cache entry in the cdp table.nd_cdp_entry_name
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1908
event_register_neighbor_discovery
To Next Page
Loading...
