Cisco Catalyst 2960 Series User Manual

ExampleDescriptionEnvironment Variable
no shutdown(Optional) The second
configuration command that is
executed.
_config_cmd2
1(Optional) A value that identifies
whether debug information for
tm_crash_reporter.tcl will be
enabled.
_crash_reporter_debug
http://www.yourdomain.com/
fm/interface_tm.cgi
The URL location to which the
crash report is sent.
_crash_reporter_url
0-59/1 0-23/1 * * 0-7A CRON specification that
determines when the policy will
run. See the “Writing Embedded
Event Manager Policies Using Tcl”
module for more information about
how to specify a cron entry.
_cron_entry
mailserver.yourdomain.comA Simple Mail Transfer Protocol
(SMTP) mail server used to send
e-mail.
_email_server
engineer@yourdomain.comThe address to which e-mail is sent._email_to
devtest@yourdomain.comThe address from which e-mail is
sent.
_email_from
manager@yourdomain.comThe address to which the e-mail is
be copied.
_email_cc
209.165.201.1 or (IPv6 address)
2001:0DB8::1
The source IP address of the
recipient.
_email_ipaddr
1.3.6.1.2.1.2 or
iso.internet.mgmt.mib-2.interfaces
The SNMP object ID._info_snmp_oid
The value string of the associated
SNMP data element.
_info_snmp_value
show versionThe CLI show command to be
executed when the policy is run.
_show_cmd
.*UPDOWN.*FastEthernet 0/0.*A regular expression pattern match
string that is used to compare
syslog messages to determine when
the policy runs.
_syslog_pattern
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1677
Information About Embedded Event Manager

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000