Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 5
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 6
startup-config
What to Do Next
To verify information about the event agent, use the show cns event connections command in privileged
EXEC mode.
To disable the CNS event agent, use the no cns event { ip-address | hostname } global configuration command.
Related Topics
Event Service, on page 410
Enabling the Cisco IOS CNS Agent
Follow these steps to enable the Cisco IOS CNS agent on the switch.
Before You Begin
You must enable the CNS event agent on the switch before you enable this agent.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
416
How to Configure the Configuration Engine

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000