SUMMARY STEPS
1.
enable
2.
configure terminal
3.
lldp holdtime seconds
4.
lldp reinit delay
5.
lldp timer rate
6.
lldp tlv-select
7.
interface interface-id
8.
lldp med-tlv-select
9.
end
10.
show lldp
11.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
(Optional) Specifies the amount of time a receiving device
should hold the information from your device before discarding
it.
lldp holdtime seconds
Example:
Switch(config)# lldp holdtime 120
Step 3
The range is 0 to 65535 seconds; the default is 120 seconds.
(Optional) Specifies the delay time in seconds for LLDP to
initialize on an interface.
lldp reinit delay
Example:
Switch(config)# lldp reinit 2
Step 4
The range is 2 to 5 seconds; the default is 2 seconds.
(Optional) Sets the sending frequency of LLDP updates in
seconds.
lldp timer rate
Example:
Switch(config)# lldp timer 30
Step 5
The range is 5 to 65534 seconds; the default is 30 seconds.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
64
How to Configure LLDP, LLDP-MED, and Wired Location Service
To Next Page
Loading...
