PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Step 5
Example:
Switch# copy-running-config startup-config
To return to the default setting, use the no mls qos srr-queue
input buffers global configuration command.
Related Topics
Queueing and Scheduling on Ingress Queues, on page 556
Examples: Configuring Ingress Queue Characteristics, on page 639
Allocating Bandwidth Between the Ingress Queues
You need to specify how much of the available bandwidth is allocated between the ingress queues. The ratio
of the weights is the ratio of the frequency in which the SRR scheduler sends packets from each queue. The
bandwidth and the buffer allocation control how much data can be buffered before packets are dropped. On
ingress queues, SRR operates only in shared mode.
SRR bandwidth limit works in both mls qos enabled and disabled states.Note
Beginning in privileged EXEC mode, follow these steps to allocate bandwidth between the ingress queues.
This procedure is optional.
SUMMARY STEPS
1.
configure terminal
2.
mls qos srr-queue input bandwidth weight1 weight2
3.
end
4.
Use one of the following:
•
show mls qos interface queueing
•
show mls qos input-queue
5.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
616
How to Configure QoS
To Next Page
Loading...
Need help?
General
