Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
If you enter the no stack-mac persistent timer command after a new active
switchstack master takes over, before the time expires, the switch stack
moves to the current active switchstack master MAC address.
Note
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
(Optional) Saves your entries in the configuration file.copy running-config
startup-config
Step 5
Example:
Switch# copy running-config
startup-config
What to Do Next
Use the no stack-mac persistent timer global configuration command to disable the persistent MAC address
feature.
Assigning a Stack Member Number
This optional task is available only from the active switchstack master.
Follow these steps to assign a member number to a stack member:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
switch current-stack-member-number renumber new-stack-member-number
4.
end
5.
reload slot stack-member-number
6.
show switch
7.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
735
How to Configure a Switch Stack

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000