Cisco Catalyst 2960 Series User Manual

Default VMPS Client Configuration
The following table shows the default VMPS and dynamic-access port configuration on client switches.
Table 197: Default VMPS Client and Dynamic-Access Port Configuration
Default SettingFeature
NoneVMPS domain server
60 minutesVMPS reconfirm interval
3VMPS server retry count
None configuredDynamic-access ports
How to Configure VMPS
Entering the IP Address of the VMPS
If the VMPS is being defined for a cluster of switches, enter the address on the command switch.Note
Before You Begin
You must first enter the IP address of the server to configure the switch as a client.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
vmps server ipaddress primary
4.
vmps server ipaddress
5.
end
6.
show vmps
7.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2154
How to Configure VMPS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000