CHAPTER 44
AAA-SERVER-MIB Set Operation
The AAA-SERVER-MIB Set Operation feature allows the authentication, authorization, and accounting
(AAA) server configuration to be extended or expanded by using the CISCO-AAA-SERVER-MIB to create
and add new AAA servers, modify the “KEY” under the CISCO-AAA-SERVER-MIB, and delete the AAA
server configuration.
•
Finding Feature Information, page 1063
•
Prerequisites for AAA-SERVER-MIB Set Operation, page 1063
•
Restrictions for AAA-SERVER-MIB Set Operation, page 1064
•
Information About AAA-SERVER-MIB Set Operation, page 1064
•
How to Configure AAA-SERVER-MIB Set Operation, page 1064
•
Configuration Examples for AAA-SERVER-MIB Set Operation, page 1065
•
Additional References for AAA-SERVER-MIB Set Operation, page 1067
•
Feature Information for AAA-SERVER-MIB Set Operation, page 1068
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for AAA-SERVER-MIB Set Operation
AAA must have been enabled on the router, that is, the aaa new-model command must have been configured.
If this configuration has not been accomplished, the set operation fails.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1063
To Next Page
Loading...
Need help?
General
