Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Disabling Message Logging
Message logging is enabled by default. It must be enabled to send messages to any destination other than the
console. When enabled, log messages are sent to a logging process, which logs messages to designated locations
asynchronously to the processes that generated the messages.
Disabling the logging process can slow down the switch because a process must wait until the messages are
written to the console before continuing. When the logging process is disabled, messages appear on the console
as soon as they are produced, often appearing in the middle of command output.
The logging synchronous global configuration command also affects the display of messages to the console.
When this command is enabled, messages appear only after you press Return.
To reenable message logging after it has been disabled, use the logging on global configuration command.
This task is optional.
SUMMARY STEPS
1.
configure terminal
2.
no logging console
3.
end
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Disables message logging.no logging console
Example:
Switch(config)# no logging console
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1603
How to Configure System Message Logs

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000