Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enters interface configuration mode and specifies the
ingress Layer 2 or Layer 3 interface to be enabled for
web-based authentication.
interface type slot/port
Example:
Switch(config)# interface gigabitEthernet1/0/1
Step 4
type can be fastethernet, gigabit ethernet, or
tengigabitethernet.
Applies the default ACL.
ip access-group name
Example:
Switch(config-if)# ip access-group webauthag
Step 5
Configures web-based authentication on the specified
interface.
ip admission name
Example:
Switch(config-if)# ip admission webauth1
Step 6
Returns to configuration mode.exit
Example:
Switch(config-if)# exit
Step 7
Enables the IP device tracking table.ip device tracking
Example:
Switch(config)# ip device tracking
Step 8
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 9
Displays the configuration.show ip admission status
Example:
Switch# show ip admission status
Step 10
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 11
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1433
How to Configure Web-Based Authentication

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000