Cisco Catalyst 2960 Series User Manual

AAA Accounting Types
Network Accounting
Network accounting provides information for all PPP, SLIP, or ARAP sessions, including packet and byte
counts.
The following example shows the information contained in a RADIUS network accounting record for a PPP
user who comes in through an EXEC session:
Wed Jun 27 04:44:45 2001
NAS-IP-Address = “172.16.25.15”
NAS-Port = 5
User-Name = “username1”
Client-Port-DNIS = “4327528”
Caller-ID = “562”
Acct-Status-Type = Start
Acct-Authentic = RADIUS
Service-Type = Exec-User
Acct-Session-Id = “0000000D”
Acct-Delay-Time = 0
User-Id = “username1”
NAS-Identifier = “172.16.25.15”
Wed Jun 27 04:45:00 2001
NAS-IP-Address = “172.16.25.15”
NAS-Port = 5
User-Name = “username1”
Client-Port-DNIS = “4327528”
Caller-ID = “562”
Acct-Status-Type = Start
Acct-Authentic = RADIUS
Service-Type = Framed
Acct-Session-Id = “0000000E”
Framed-IP-Address = “10.1.1.2”
Framed-Protocol = PPP
Acct-Delay-Time = 0
User-Id = “username1”
NAS-Identifier = “172.16.25.15”
Wed Jun 27 04:47:46 2001
NAS-IP-Address = “172.16.25.15”
NAS-Port = 5
User-Name = “username1”
Client-Port-DNIS = “4327528”
Caller-ID = “562”
Acct-Status-Type = Stop
Acct-Authentic = RADIUS
Service-Type = Framed
Acct-Session-Id = “0000000E”
Framed-IP-Address = “10.1.1.2”
Framed-Protocol = PPP
Acct-Input-Octets = 3075
Acct-Output-Octets = 167
Acct-Input-Packets = 39
Acct-Output-Packets = 9
Acct-Session-Time = 171
Acct-Delay-Time = 0
User-Id = “username1”
NAS-Identifier = “172.16.25.15”
Wed Jun 27 04:48:45 2001
NAS-IP-Address = “172.16.25.15”
NAS-Port = 5
User-Name = “username1”
Client-Port-DNIS = “4327528”
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1007
Information About Configuring Accounting

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000