Cisco Catalyst 2960 Series User Manual

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ipv6 nd suppress policy policy-name
4.
mode dad-proxy
5.
mode full-proxy
6.
mode mc-proxy
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters the global configuration mode.configure terminal
Step 2
Defines the Neighbor Discovery suppress policy name and enters
Neighbor Discovery suppress policy configuration mode.
ipv6 nd suppress policy policy-name
Step 3
Enables Neighbor Discovery suppress in IPv6 DAD proxy mode.mode dad-proxy
Step 4
Enables Neighbor Discovery suppress to proxy multicast and unicast
Neighbor Solicitation messages.
mode full-proxy
Step 5
Enables Neighbor Discovery suppress to proxy multicast Neighbor
Solicitation messages.
mode mc-proxy
Step 6
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Attach an IPv6 Neighbor Discovery Multicast Suppress Policy on an Interface
To attach an IPv6 Neighbor Discovery Multicast Suppress policy on an interface, complete the following
steps:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
692
How to Attach an IPv6 Neighbor Discovery Multicast Suppress Policy on a Device

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000