Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Verifies the configuration.Use one of the following:
Step 7
•
show location admin-tag string
•
show location civic-location identifier id
•
show location elin-location identifier id
Example:
Switch# show location admin-tag
or
Switch# show location civic-location
identifier
or
Switch# show location elin-location
identifier
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 8
startup-config
Enabling Wired Location Service on the Switch
Before You Begin
For wired location to function, you must first enter the ip device tracking global configuration command.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
nmsp notification interval {attachment | location} interval-seconds
4.
end
5.
show network-policy profile
6.
copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
72
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000