Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy-running-config
Step 5
startup-config
Related Topics
Default IP-Precedence-to-DSCP Map, on page 569
Examples: Configuring DSCP Maps, on page 637
Configuring the Policed-DSCP Map
You use the policed-DSCP map to mark down a DSCP value to a new value as the result of a policing and
marking action.
The default policed-DSCP map is a null map, which maps an incoming DSCP value to the same DSCP value.
Beginning in privileged EXEC mode, follow these steps to modify the policed-DSCP map. This procedure
is optional.
SUMMARY STEPS
1.
configure terminal
2.
mls qos map policed-dscp dscp-list to mark-down-dscp
3.
end
4.
show mls qos maps policed-dscp
5.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Modifies the policed-DSCP map.
mls qos map policed-dscp dscp-list to mark-down-dscp
Step 2
Example:
Switch(config)# mls qos map
•
For dscp-list, enter up to eight DSCP values separated
by spaces. Then enter the to keyword.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
607
How to Configure QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000