Event_reqinfo
"event_id %u event_type %u event_type_string {%s} %u event_pub_sec %u event_pub_msec %u"
"event_severity {%s} %u network %u mask %u protocol %u lastgateway %u distance %u" "time_sec %u
time_msec %u metric %u lastinterface %u"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
An ASCII string that represents the name of the event
for this event type.
event_type_string
The time, in seconds and milliseconds, when the event
was published to the EEM.
event_pub_sec event_pub_msec
The severity of the event.event_severity
The network prefix in IP address formatnetwork
The network mask in IP address formatmask
Type of network protocol.protocol
Type of event to add, remove or modify.type
The last known gateway.lastgateway
The administrative distance.distance
Time of event in seconds and milliseconds, when the
event was published to the EEM.
time_sec time_msec
Path metric.metric
The last known interface.lastinterface
event_register_rpc
Registers for an event that is triggered by the EEM SSH Remote Procedure Call (RPC) command. These
events are handled by the RPC event detector that screens for this event. Use this Tcl command extension to
run a RPC policy for this script.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1930
event_register_rpc
To Next Page
Loading...
Need help?
General
