PurposeCommand or Action
Specifies the port to be configured, and enter interface
configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet2/0/4
Step 6
Configures the default ACL on the port in the input
direction.
ip access-group acl-id in
Example:
Switch(config-if)# ip access-group default_acl in
Step 7
The acl-id is an access list name or
number.
Note
Verifies your configuration.
show running-config interface interface-id
Example:
Switch(config-if)# show running-config interface
Step 8
gigabitethernet2/0/4
(Optional) Saves your entries in the configuration
file.
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 9
Configuring a Downloadable Policy
Beginning in privileged EXEC mode:
SUMMARY STEPS
1.
configure terminal
2.
access-list access-list-number { deny | permit } { hostname | any | host } log
3.
interface interface-id
4.
ip access-group acl-id in
5.
exit
6.
aaa new-model
7.
aaa authorization network default group radius
8.
ip device tracking
9.
ip device tracking probe [count | interval | use-svi]
10.
radius-server vsa send authentication
11.
end
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1402
How to Configure 802.1x Port-Based Authentication
To Next Page
Loading...
