CHAPTER 7
Configuring Boot Fast
•
Finding Feature Information, page 81
•
Configuring Boot Fast on the switch, page 81
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Configuring Boot Fast on the switch
This features when enabled, helps the switch to Boot up fast. The Memory test is performed for a limited
range, the switch Skips File system check (FSCK) and Skips Post test.
Enabling Boot Fast
To enable the boot fast feature, perform the following steps:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
boot fast
4.
end
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
81
To Next Page
Loading...
Need help?
General
