Cisco Catalyst 2960 Series

PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 6
startup-config
Setting the Stack Port Speed to 10 Gbps
In a mixed stack of Catalyst 2960-X and 2960-S switches, you must set the stack port speed to 10 Gbps. This
task is required in a mixed stack configuration and must be run on a Catalyst 2960-X switch in the switch
stack before you add a 2960-S switch to the stack. Otherwise, the switches will not stack.
SUMMARY STEPS
1.
configure terminal
2.
switch stack port-speed 10
3.
end
4.
copy running-config startup-config
5.
reload
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Sets the stack port speed to 10 Gbps.switch stack port-speed 10
Example:
Switch(config)# switch stack port-speed 10
Step 2
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
738
How to Configure a Switch Stack