Cisco Catalyst 2960 Series

DETAILED STEPS
PurposeCommand or Action
Verifies which interfaces are alternate or root
ports.
Enter one of the following commands:
Step 1
•
show spanning-tree active
•
show spanning-tree mst
Example:
Switch# show spanning-tree active
or
Switch# show spanning-tree mst
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Enables loop guard.spanning-tree loopguard default
Step 3
Example:
Switch(config)# spanning-tree loopguard default
By default, loop guard is disabled.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Related Topics
Loop Guard, on page 298
Enabling PortFast Port Types
This section describes the different steps to enable Portfast Port types.
Related Topics
STP PortFast Port Types, on page 298
Configuring the Default Port State Globally
To configure the default PortFast state, perform this task:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
314
How to Configure Optional Spanning-Tree Features