Cisco Catalyst 2960 Series User Manual

(Optional) Specifies that if event 1 occurs the action
is executed, and if event 2 and event 3 occur together
the action is not executed.
andnot
(Optional) Specifies that if event 1 occurs the action
is executed, and if event 2 and event 3 occur together
the action is executed.
When "and" is used to group events such as
traps or syslog messages, then the default
trigger occurrence window is three minutes.
Note
and
(Optional) Specifies that if event 1 occurs the action
is executed, or else if event 2 and event 3 occur
together the action is executed.
or
Result String
None
Set _cerrno
No
trigger
Specifies the multiple event configuration ability of Embedded Event Manager (EEM) events. A multiple
event is one that can involve one or more event occurrences, one or more tracked object states, and a time
period for the event to occur. The events are raised based on the specified parameters.
Syntax
trigger [occurs ?] [period ?] [period-start ?] [delay ?]
Arguments
(Optional) Specifies the number of times the total
correlation occurs before an EEM event is raised.
When a number is not specified, an EEM event is
raised on the first occurrence. The range is from 1 to
4294967295.
occurs
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1989
trigger

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000