PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Configuring a Multicast Router Port
Perform these steps to add a multicast router port (enable a static connection to a multicast router) on the
switch.
Static connections to multicast routers are supported only on switch ports.Note
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip igmp snooping vlan vlan-id mrouter interface interface-id
4.
end
5.
show ip igmp snooping mrouter [vlan vlan-id]
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the multicast router VLAN ID and the interface to the
multicast router.
ip igmp snooping vlan vlan-id mrouter interface
interface-id
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
132
How to Configure IGMP Snooping and MVR
To Next Page
Loading...
