Cisco Catalyst 2960 Series User Manual

(Optional) Priority level at which the script will be
queued:
•
queue_priority low--Specifies that the script is
to be queued at the lowest of the three priority
levels.
•
queue_priority normal--Specifies that the script
is to be queued at a priority level greater than
low priority but less than high priority.
•
queue_priority high--Specifies that the script is
to be queued at the highest of the three priority
levels.
•
queue_priority last--Specifies that the script is
to be queued at the lowest priority level.
If more than one script is registered with the
"queue_priority_last" argument set, these scripts will
execute in the order in which the events are published.
The queue_priority argument specifies the
queuing priority, but not the execution
priority, of the script being registered.
Note
If this argument is not specified, the default queuing
priority is normal.
queue_priority
(Optional) Maximum run time of the script (specified
in SSSSSSSSSS[.MMM] format, where SSSSSSSSSS
must be an integer representing seconds between 0
and 4294967295, inclusive, and where MMM must
be an integer representing milliseconds between 0
and 999). If this argument is not specified, the default
20-second run-time limit is used.
maxrun
(Optional) Policy run-time priority setting. When the
nice argument is set to 1, the policy is run at a
run-time priority that is less than the default priority.
The default value is 0.
nice
Result String
None
Set _cerrno
No
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1926
event_register_rf

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000